Искал причину в интернете,ничего не помогло.
при вводе в консоли sane-find-scanner
Код: Выделить всё
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
# Also you need support for SCSI Generic (sg) in your operating system.
# If using Linux, try "modprobe sg".
found USB scanner (vendor=0x04a9 [Canon], product=0x176d [MG2500 series]) at libusb:002:006
found USB scanner (vendor=0x12d1, product=0x1003) at libusb:003:005
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
# You may want to run this program as root to find all devices. Once you
# found the scanner devices, be sure to adjust access permissions as
# necessary.Добавил пользователя в группу scanner.
tolya lp wheel users vboxusers scanner sambashare
но ничего не изменилось.
далее делал по http://www.altlinux.org/%D0%9D%D0%B0%D1 ... _ALT_Linux
Код: Выделить всё
bash-4.3$ scanimage -L
device `v4l:/dev/video0' is a Noname 1.3M WebCam virtual device
device `pixma:04A9176D_01A7E7' is a CANON Canon PIXMA MG2500 Series multi-function peripheralа вот тестирование работы
Код: Выделить всё
bash-4.3$ scanimage -T
scanimage: sane_start: Invalid argumentВ чем может быть причина???помогите пожалуйста....
