МФУ kyocera m5521cdn

Ответить
lexa
Сообщения: 115
Зарегистрирован: 17 апр 2016, 08:10
Operating system: Rosa 7 86_64

МФУ kyocera m5521cdn

Сообщение lexa » 02 май 2018, 05:57

Здравствуйте уважаемые заядлые форумчане и гости.
Приобрел сея агрегат и подключил через USB, принтер поднял согласно инструкции, но вот сканер...."некоторые запрошенные пакеты не могут быть установлены: kyodialog-0-0.x86_64(из-за неудовлетворенности cups-libs)"
Бродил по дремучим лесам, но ничего сделать не смог. Пытался установить sane-backends 1.0.27 и опять мимо. Помогите, а тож хочется на росе сея МФУ юзать, а не через винду. Кстати (для разработчиков): отсутствует kyocera в перечне принтеров, хотя сразу определяется системой, но драйвера не подставляет, в настройках принтера рекомендуемый драйвер "женерик" печатает черно белым
scanimage -L
[epsonds] unable to parse config line: net autodiscovery

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
sane-find-scanner tool

# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.

# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
# Also you need support for SCSI Generic (sg) in your operating system.
# If using Linux, try "modprobe sg".

# No USB scanners found. If you expected something different, make sure that
# you have loaded a kernel driver for your USB host controller and have setup
# the USB system correctly. See man sane-usb for details.

# Not checking for parallel port scanners.

# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.

# You may want to run this program as root to find all devices. Once you
# found the scanner devices, be sure to adjust access permissions as
# necessary.
lsusb
Bus 001 Device 002: ID 0482:06b1 Kyocera Corp.

Ответить

Вернуться в «Обсуждение ROSA Fresh R4 - R8 (платформа 2014.1)»